Following your enclosure location plan, install the control enclosure.
About this task
The installation procedure applies to
control enclosures.
Each control enclosure must be installed only on the control enclosure rails provided with the
enclosure.
CAUTION:
To lift a control enclosure requires a lifting machine or at
least three people.
Install a control enclosure only onto the control enclosure rails supplied with the
enclosure.
Load the rack from the bottom up to ensure rack stability. Empty the rack from the top
down.
Procedure
To install a control enclosure, complete the following steps.
Align the enclosure with the front of the rack cabinet.
Align the inner part of the rail which is attached to the
enclosure with the outer part of the rail which is attached to the rack.
Figure 1. Aligning the rails
Slide the enclosure into the rack along the rails until the enclosure stops halfway. (See Figure 2).
Figure 2. Inserting the enclosure
Operate the blue latches on the rails on each side of the
enclosure so that the enclosure can be pushed all the way into the rack.
Figure 3. Operating blue latches on the rail
What to do next
If you removed components from the enclosure to lift it, reinstall the components into the slots
of the enclosure from which they were removed.
Fit the bezel to the front of the enclosure by hooking on the left side
of the bezel and punching the right side of the bezel up against the enclosure.
You can optionally fit a Kensington lock to secure the bezel
after installation.Figure 4. Fitting the bezel
In the management GUI panel
Monitoring > System Hardware,
you can change the bezel color by using the Bezel settings option under the
Enclosure actions menu. The bezel light turns off when the enclosure
identification light turns
on.
