lsnodeip

Use the sainfo lsnodeip command to list the node IP addresses of Ethernet ports on the node.

Syntax

Read syntax diagramSkip visual syntax diagram sainfo lsnodeip panel_name

Parameters

-delim delimiter
(Optional) Specify a delimiter to separate data in the output.
-nohdr
(Optional) Suppress the headings in the output.
panel_name
(Optional) Specifies the system or node on which the command is invoked. The value must be an alphanumeric.

Description

This command lists the node IP addresses for Ethernet ports on a node.

This table provides the attribute values that can be displayed as output view data.
Table 1. sainfo lsnodeip output
Attribute Description
port_id Indicates the Ethernet port ID on the node. The ID can be a value in the range 1 - 28.

For more information, see the lsservicestatus command.
rdma_type Indicates the RDMA Capabilities of the port. The values are colon-separated (Example: RoCE:iWARP).
Note: When the node IP is configured, the node usage is still unknown between NVMe over RDMA or NVMe over TCP. Therefore, both usages are represented with the RoCE value.
port_speed Indicates the speed of the port in Gbps.
vlan Indicates the Virtual LAN identifier of the port.
link_state Indicates whether the port is active or inactive.
state Indicates whether an IP Address for clustering purposes is assigned to the Ethernet Port. The possible values are configured or unconfigured (default).
node_IP_address Indicates the Internet Protocol Version 4 (IPv4) node IP address.
subnet_mask Indicates the IPv4 subnet mask value.
gateway Indicates the IPv4 gateway address.