You will use this information to
complete system registration for IBM Call Home and IBM® Storage Insights.
Step 1: Call Home asset registration information
Complete the following table of information so that you can use it to register each enclosure
that you've purchased, after the system is installed:
Table 1. Call Home asset registration information
| Step 1 - Asset registration |
| Your customer number |
|
| MTMs to register |
|
| Serial numbers to register |
|
| Your time zone |
|
| To prevent over-alerting, specify the usage
category for each serial number that you are registering. Selections are: development, test, or
production |
|
| Enter the logical name for each serial number
that you are registering. |
|
Step 2: Add the system owner and key contacts
Complete the following table to register the owner and key contact for the systems that you've
purchased:
Step 3: Application setup information
Complete the following table of information so that you can register and set up each
application:
Table 3. Call Home application setup information
| Step 3A - Call Home User Interface |
| Decide if you want to use the Call Home user
interface. |
|
| Step 3B - IBM Storage Insights online |
| Enter the IP address for your IBM Storage Insights Cloud account. |
|
Step 4: Verify a Call Home event as a test
As the final step of activating IBM Call Home and registering your system, after the system is
installed, you will send a test Call Home event. You should not need to provide any further
information to send the test event, but you'll want to record whether the test was successful.
Table 4. Call Home test information
| Step 4 - Call Home test event |
| Was the Call Home event sent successfully? |
|