Port settings for HP MA and EMA systems

Port settings are configurable at the port level.

Restriction: Only one port per HSG80 pair can be used with the system.

The port settings are set by using the following commands:

SET THIS PORT_1_TOPOLOGY=FABRIC
SET THIS PORT_2_TOPOLOGY=FABRIC
SET OTHER PORT_1_TOPOLOGY=FABRIC
SET OTHER PORT_2_TOPOLOGY=FABRIC

These values can be checked by using the following commands:

SHOW THIS
SHOW OTHER

Table 1 lists the HSG80 controller port settings that the system supports.

Table 1. Supported HSG80 controller port settings
Option	HSG80 default setting	Required system setting
PORT_1/2-AL-PA	71 or 72	Not applicable
PORT_1/2_TOPOLOGY	Not defined	FABRIC

Note: The HP MA and EMA systems support LUN masking that is configured with the

SET
unit number ENABLE_ACCESS_PATH

command. When used with the system, the access path must be set to all (SET unit number ENABLE_ACCESS_PATH=ALL). All LUN masking must also be handled exclusively by the system. You can use the SHOW CONNECTIONS FULL command to check access rights.