chnodeled

Edit online

Use the chnodeled command to turn the identification light-emitting diode (LED) on or off for the specified node or control canister.

Syntax

Read syntax diagramSkip visual syntax diagram satask chnodeled -on-off panel_name

Parameters

-on | -off
(Required) Turns the identification LED for the specified node or control canister on or off.
panel_name
(Optional) Specifies a unique panel name used to apply the command to a valid node on the fabric.
Note: If panel_name is not supplied, this applies to the node on which the command is running.

Description

This command turns the canister identification LED on or off.
Note: The identification LED is mapped onto the physical LEDs using different methods, depending on your hardware. Refer to the documentation for your hardware platform for more information.

An invocation example to turn on the LED to identify the battery in slot 2 on node KP2812

satask chnodeled -on -battery 2 KP2812

The resulting output:

No feedback

An invocation example to turn on the LED to identify the battery on node 2

satask chnodeled -on -battery 2

The resulting output:

No feedback

An invocation example to allow the node to identify the LED

satask chnodeled -on

The resulting output:

No feedback

An invocation example to turn on the LED for canister 1 in control enclosure 02

satask chnodeled -on 02-1

The resulting output:

No feedback