Installing the control enclosure in a rack

After you install the support rails, you can install the control enclosure in the rack.

Before you begin

CAUTION:

To avoid any hazard from the rack tipping forward when devices are installed, observe all safety precautions for the rack into which you are installing the device.

CAUTION:

The weight of this part or unit is between 18 and 32 kg (39.7 and 70.5 lb). It takes two persons to safely lift this part or unit. (C009)

Important: The control enclosure requires high line (200-240 V) power. If the power supplies have the auto-ranging PSU (03GH925), they can also accept 100-127 V.

To install the control enclosure in the rack, complete the following steps.

1. Using two persons, lift the chassis until the back of the control enclosure is aligned with the front of the rack rails.
   Note: Make sure that the FAN door is pointing up.
2. Slide the control enclosure between the rails.

   

3. When fully inserted, the enclosure latch on each front corner of the control enclosure engages with the blue hook on the vertical rail of the rack.
   Note: If the rack is being moved, you can use the captive screws under the enclosure latch levers to secure the enclosure to the rails.