chnodecanister
You can use the chnodecanister command to change the name that is assigned to a node and other options. The name can then be used when running subsequent commands. All the parameters that are associated with this command are optional. However, you must specify one or more parameters with this command.
Syntax
Parameters
- -iscsialias alias
- (Optional) Specifies the iSCSI name of the node. The maximum length is 79 characters.
- -noiscsialias
- (Optional) Clears any previously set iSCSI name for this node. This parameter cannot be specified with the iscsialias parameter.
- -failover
- (Optional) Specifies that the name or iSCSI alias being set is the name or alias of the partner node in the I/O group. When there is no partner node, the values set are applied to the partner node when it is added to the system. If this parameter is used when there is a partner node, the name or alias of that node changes.
- -name new_nodecanister_name
- (Optional) Specifies the name to assign to the node canister.Note: Node canister names supplied with -name on chnodecanister commands must not be in use already as node canister names or as node canister failover names.Important: The iSCSI Qualified Name (IQN) for each node canister is generated using the system and node canister names. If you are using the iSCSI protocol, changing either name also changes the IQN of all of the node canisters in the system and might require reconfiguration of all iSCSI-attached hosts.
- -identify yes | no
- (Optional) Allows you to control the light-emitting diode (LED) used on the node. The values are yes or no.
- -site site_id | site_name
- (Optional) Specifies the numeric site value or site name for the existing node. The
value for site_id is
1
or2
. The value for site_name is an alphanumeric string. - -nosite
- (Optional) Resets the site value.
- object_id | object_name
- (Required) Specifies the object name or ID that you want to modify. The variable that
follows the parameter is either:
- The object name that you assigned when you added the node canister to the system
- The object ID that is assigned to the node canister (not the worldwide node name)
Description
If the failover parameter is not specified, this command changes the name of the node canister. You can then use the name to identify the node canister in subsequent commands.
If the failover parameter is not specified, this command changes the name or iSCSI alias of the node canister. You can then use the name to identify the node canister in subsequent commands.
The failover parameter is used to specify values that are normally applied to the partner node in the I/O group. When the partner node is offline, the iSCSI alias and IQN are assigned to the remaining node canister in the I/O Group. The iSCSI host data access is then preserved. If the partner node is offline when these parameters are set, the node canister they are set on handles iSCSI I/O requests to the iSCSI alias specified, or the IQN that is created using the node canister name. If the partner node canister in the I/O group is online when these parameters are set, the partner node canister handles iSCSI requests to the iSCSI alias specified, and its node canister name and IQN change.
- Make sure the host system has active sessions with both node canisters in the I/O group (hosting the volume on which the I/O occurs).
- Change name of one node canister using chnode command.
- From the host system, log out of the node canister whose name changes.
- Rediscover the target iSCSI qualified name (IQN) from the host using the host operating system's discovery mechanism.
- Login with the new target IQN discovered on the host system, and make sure the login succeeds.
- Repeat steps 2-5 with the other node canister.
An invocation example
chnode -name newname -identify yes node8
The resulting output:
No feedback