installsoftware
Use the command to install a specific system code package and a specific patch on a single node.
Syntax
Parameters
- -file filename
- (Required) The file name of code installation package. Note: The argument to -file must be present on the local node; the argument is automatically copied to the target panel_name.
- patch_name
- Specifies the name of the patch file.
- code_package
-
Specifies the name of the code package uploaded on the configuration node.
- -purgepatches
- When a code package is installed on a system, all the existing patches are reapplied. When you specify the -purgepatches parameter, all the existing patches on the node are removed.
- -ignore
- (Optional) Overrides prerequisite checking and forces installation of the code.
- -pacedccu
- (Optional) Causes the node to initiate a paced Concurrent Code Update (in which you define when the node begins its update) instead of a normal Concurrent Code Update (in which each node in the clustered system automatically updates in sequence).
- panel_name
- (Optional) Identifies the node that is being serviced. Note: If
panel_nameis not supplied, this applies to the node on which the command is running.
Description
This command installs a specific code package and a specific patch on a single node. You can also use this command to install a code package without installing a patch.
Important: Use this command only under the direction of your support team.
An invocation example
satask installsoftware -file install_pkg.gpg nodeB_panel_nameThe resulting output:
No feedback.