Run the report with data completeness check enabled

You can use Data completeness check to verify whether a specific report has problems.

Before you begin

The Data completeness check option is not available on the Run report page by default. If you want to use this option, contact your system administrator.

As a system administrator, you can perform the following steps to enable the Data completeness check option:
  1. Add the enable.lqe.data.completeness.check.feature property in the JTS_install_dir/server/conf/rs/app.properties file.
    Warning: Ensure that the enable.lqe.data.completeness.check.feature property does not contain any white space, neither between the equal sign or at the end of the line. The use of white space might prevent this property from working properly.
  2. Set the property value as true.
  3. Restart the Report Builder server.

For more information, see Data completeness check in Report Builder: