Managing configuration details

Edit online

You can open a local configuration to see related configurations, manage details, compare configurations, and create local configurations.

Before you begin

Ensure that you are familiar with project areas, components (if supported), baselines, streams, and change sets (if supported).
Ensure that you are logged in to a project.

Procedure

On the toolbar, click Administration > Manage Components and Configurations.
Complete the steps depending on the IBM® Engineering Lifecycle Management application that you use:
- DOORS® Next: Click a stream name.
  Tip: To go to another component, click the Browse Components breadcrumb link and click a stream name.
- Engineering Test Management: In the pane, click Streams or Baselines.

Results

The configuration editor opens. There are several things that you can do from this editor, depending on the Engineering Lifecycle Management application that you use.

In the DOORS Next application:

To change the configuration name, click its name on the page, type the new name, and then click Save.
To list the change sets, child streams, and baselines of this stream, click the corresponding tab name.
To change the description, click the Details tab, provide text that uniquely identifies the configuration, and then click Save.
See the icons near the start of the page for tasks that you can complete depending on the type of configuration you are viewing.
Where it exists, see the Actions menu next to the configuration name for the tasks that you can complete.
For streams:
- To view or edit artifacts for a stream, click Explore Stream.
- To see which streams are derived from this stream, click the Streams tab. For each stream on the page, see the menu in the Actions column for actions that you can take.
- To see which baselines were created from this stream, click the Baselines tab. Then, to view the baseline artifacts, click Actions > Explore Baseline.

In the application:

To view the details of a configuration, hover over its name in the table.
To change the configuration name or description, click its name in the table. Then, in the properties window, provide text that uniquely identifies the configuration, and click OK.
See the Actions menu next to the configuration name for the tasks that you can complete.
To work with the artifacts in a configuration, click its name or click Actions > Switch to This configuration type.
See the controls near the table to change how the page is shown.

What to do next

To return to an Engineering Lifecycle Management project area, click Home Menu

, and select the application and project area to return to. On the toolbar, verify that you are in the configuration that you want to work in. To switch configurations, click the configuration name.