Syslog log source parameters for Pulse Secure Infranet Controller

If QRadar® does not automatically detect the log source, add a Pulse Secure Infranet Controller log source on the QRadar Console by using the syslog protocol.

When using the syslog protocol, there are specific parameters that you must use.

The following table describes the parameters that require specific values to collect syslog events from Pulse Secure Infranet Controller:
Table 1. Syslog log source parameters for the Pulse Secure Infranet Controller DSM
Parameter Value
Log Source type Juniper Networks Infranet Controller
Protocol Configuration Syslog

After you configure syslog for your Pulse Secure Infranet Controller, you are now ready to configure the log source in QRadar.