Configuring a Juniper Steel-Belted Radius log source by using the Syslog protocol

If you want to collect Juniper Steel-Belted Radius logs from a Juniper Steel-Belted Radius device, configure a log source on the QRadar Console so that Juniper Steel-Belted Radius can communicate with QRadar by using the Syslog protocol.

Procedure

  1. If automatic updates are not enabled, download and install the most recent version of the following RPMs from the IBM® Support Website onto your QRadar Console.
    • DSMCommon RPM
    • Juniper Steel Belt Radius DSM RPM
  2. Configure your Juniper Steel-Belted Radius device to send syslog events to QRadar.
  3. Add a Syslog log source on the QRadar Console.

    The following table describes the parameters that require specific values to collect Syslog events from Juniper Steel-Belted Radius by using the Syslog protocol:

    Table 1. Syslog protocol log source parameters
    Parameter Description
    Log Source Type Juniper Steel-Belted Radius
    Protocol Configuration Syslog