Configuring a trap receiver for Cisco Wireless LAN Controller

Trap receivers that are configured on Cisco Wireless LAN Controllers define where the device can send SNMP trap messages.

About this task

To configure a trap receiver on your Cisco Wireless LAN Controller, take the following steps:

Procedure

  1. Click the Management tab.
  2. From the menu, select SNMP > Trap Receivers.
  3. In the Trap Receiver Name field, type a name for your trap receiver.
  4. In the IP Address field, type the IP address of IBM QRadar.

    The IP address you specify is the address to which your Cisco Wireless LAN Controller sends SNMP messages. If you plan to configure this log source on an Event Collector, you want to specify the Event Collector appliance IP address.

  5. From the Status list, select Enable.
  6. Click Apply to commit your changes.
  7. Click Save Configuration to save your settings.

What to do next

You are now ready to create a SNMPv2 log source in QRadar.