Additional Helm parameters

You can find the information about Helm parameters that you can use during the installation of IBM® DevOps Loop.

As a system administrator, you must complete the additional configuration for the capabilities by using Helm parameters. Each Helm parameter that is specific to the solution is prefixed by its Helm chart name as follows:

Plan: ibm-devopsplan-prod
Test: ibm-devops-prod
Deploy: ibm-ucd-prod
Measure: ibm-ucv-prod

For example, to configure a property in Plan, use the following command:

bash
--set ibm-devopsplan-prod.property=value

For more information on the Helm parameters, refer to the following documents:

README of Plan
README of Test
README of Deploy
README of Measure