Controlling browse mode
Browse mode can be controlled (activated or deactivated)
by changing RACF® access, specifying
the EQAOPTS
BROWSE command, both of these, or neither
of these. To control browse mode through RACF access, change your RACF access to the following RACF Facilities: - For CICS®: EQADTOOL.BROWSE.CICS
- For non-CICS: EQADTOOL.BROWSE.MVS
To control browse mode through an EQAOPTS command, specify
either ON or OFF for the EQAOPTS BROWSE command.
The following table shows how combinations
of these control methods (by RACF access
or by the EQAOPTS BROWSE command) can activate or
deactivate browse mode. For instructions using these controls
see IBM®
z/OS Debugger Customization Guide.
| Status of RACF access | Setting
of the EQAOPTS BROWSE command |
||
|---|---|---|---|
| Not set (use RACF status) | ON | OFF | |
| facility (access) not defined | normal mode (browse mode is not active) | browse mode is active | normal mode |
| ACCESS=NONE | Cannot use z/OS® Debugger | Cannot use z/OS Debugger | Cannot use z/OS Debugger |
| ACCESS=READ | browse mode is active | browse mode is active | browse mode is active |
| ACCESS=UPDATE (or higher) | normal mode | browse mode is active | normal mode |