Running the EQASET transaction for non-Language Environment® IMS MPPs

Running the EQASET transaction indicates to the EQANIAFE application front-end routine that you want to do one of the following functions:

• Enable a debugging session with the preferences you indicate
• Request information about your existing preferences
• Disable a debugging session

To enable a debugging session, select one of the following options:

• To debug in full-screen mode using a dedicated terminal without Terminal Interface Manager, enter the command EQASET MFI=terminal_LU_name. If you are required to specify a VTAM® network identifier, enter the command EQASET MFI=network_identifier.terminal_LU_name.
• To debug in full-screen mode using the Terminal Interface Manager, enter the command EQASET VTAM=user_ID.
• To debug in remote debug mode, enter the command EQASET TCP=IP_address%port_number.

After you enter an EQASET command, on the same terminal, start the transaction that is associated with the application program that you want to debug.

To request information about your existing preferences, enter the command EQASET STATUS.

To disable a debugging session, enter the command EQASET OFF.

To re-enable a debugging session after using EQASET OFF, enter the command EQASET ON.