Verifying the customization of the facility to debug full-screen mode using a dedicated terminal

Connect a terminal emulator session to one of the terminal LUs setup as described previously in this chapter. Issue the DISPLAY command from your system console as shown in Terminal LU state requirements. Verify that the output of the DISPLAY command is correct. If the output of the DISPLAY command is not correct, you must review every step in Enabling full-screen mode using a dedicated terminal and verify that you completed each step correctly. Then run one of the install verification jobs described below.

To help you verify the installation of the facility to debug full-screen mode using a dedicated terminal, the hlq.SEQASAMP data set contains the following installation verification program (IVP) jobs:

• EQAWIVP5 (COBOL)
• EQAWIVP6 (C)
• EQAWIVP7 (PL/I)
• EQAWIVP9 (Enterprise PL/I)
• EQAWIVPB (Language Environment® assembler)
• EQAWIVPD (non-Language Environment assembler)
• EQAWIVPW (OS/VS COBOL)
• EQAWIVPY (non-Language Environment VS COBOL II)

Before you run a sample, customize it for your installation as described in the sample.