Installing, updating, and uninstalling automated failover scripts for the IBM Tivoli System Automation for Multiplatforms (SA MP) using Db2 installer

You can install, upgrade, or uninstall IBM® Tivoli® System Automation for Multiplatforms (SA MP) automated failover scripts using the Db2 installer.

Before you begin

Whether you use the Db2 installer or manually install, upgrade, or uninstall SA MP automated failover scripts, you must meet the basic prerequisites for installing, upgrading, and uninstalling SA MP automated failover scripts. See: Installing, updating, and uninstalling automated failover scripts for the IBM Tivoli System Automation for Multiplatforms (SA MP).

There are three methods for using the Db2 installer to install or uninstall:

Db2 Setup wizard (install, upgrade, or uninstall)
Silent installation by using a response file with db2setup (install or upgrade) or db2unins (for uninstall)
db2_install command (for install), installFixPack command (for upgrade), or db2_deinstall command (for uninstall)

To install the SA MP automated failover scripts, run the Db2 installer.

By default, the Db2 installer installs the SA MP automated failover scripts if SA MP is installed or being installed, and the scripts are not already installed.
To upgrade the SA MP automated failover scripts, run the Db2 installer.

By default, the Db2 installer will upgrade the SA MP automated failover scripts if SA MP is installed or being installed, and the scripts that are already installed are at a lower version than the version of the scripts that are on the Db2 install media.
To uninstall the SA MP automated failover scripts, run the Db2 installer.

Whether you use the Db2 installer or manually install, upgrade, or uninstall the SA MP automated failover scripts, the general results are the same, see Installing, updating, and uninstalling automated failover scripts for the IBM Tivoli System Automation for Multiplatforms (SA MP).