IRR916I RACF/Db2 EXTERNAL SECURITY MODULE WAS ASSEMBLED WITH AN [ HRF7720 OR EARLIER | HRF7730 OR LATER ] MACRO LIBRARY. Db2 ROLES AS RACF CRITERIA ARE [NOT] SUPPORTED.

Explanation

This message is issued when the Db2 V9 RACF access control module is used, to indicate whether or not the module supports Db2 roles.

The module does not fully support Db2 roles if it is invoked from a Db2 V9 system and any of the following sets of conditions are true:

  • The system is running z/OS® V1R7 and the RACF access control module was assembled with z/OS V1R7 macros.
  • The system is running z/OS V1R7 and the RACF access control module was assembled with z/OS V1R8 macros.
  • The system is running z/OS V1R8 and the RACF access control module was assembled with z/OS V1R7 macros.

The module fully supports Db2 roles if is invoked from a Db2 V9 system and the following set of conditions is true:

  • The system is running z/OS V1R8 (or higher) and the RACF access control module was assembled with z/OS V1R8 (or higher) macros.

System action

The RACF access control module continues.

System programmer response

If the message indicates that Db2 roles as RACF criteria are not supported, and you need this support, reassemble the RACF access control module with the HRF7730 or later macro library to fully enable support for roles in the module when Db2 is running on z/OS V1R8 or later. The version of the module shipped with Db2 V9 must be assembled with the Db2 V9 macros, link-edited, and installed in a library that is accessible to your Db2 subsystem.

If the message indicates that Db2 roles are supported as RACF criteria, no further action is required.

Routing code

Descriptor code is 4. Routing codes are 9 and 10.