DSNT715E ERROR reason-code READING table-name. default WILL BE RESOURCE LIMIT FOR CORRELATION-ID correlation-id, CONNECTION-ID connection-id, LUW-ID luw-id =token

Explanation
 An error occurred while the resource limit specification
table 'table-name' was being read. The limit is determined from the
default specified in the system parameters. This default can be:  

NOLIMIT

No limit applies.

NORUN

Zero time limit.

integer

The limit to be used.

 The reason code that defines the read error is included
in the message text, as are the 'connection-ID', 'correlation-ID',
and the logical-unit-of-work identifier (LUW-ID) of the thread. An
LUW-ID of an '*' indicates that the thread does not have a LUW-ID.
If the LUW-ID is not an '*', the value is a logical-unit-of-work-id
that is assigned to the thread followed by an '=' sign and a token
value, which can be used in place of logical-unit-of-work-id in any Db2 command that accepts logical-unit-of-work-id
as input. Correlation IDs beginning with '0nn', where 'nn' is a number
from 01 to 28, identify system agents.

System action
 Processing continues using the system-defined
default.

Operator response
 Notify the system programmer.

System programmer response
 This is an I/O error. Investigate
the problem indicated by the reason code and preceding messages. If you suspect an error in Db2, you might need to report the problem. For information about identifying and reporting the
problem, see Collecting diagnostic data.

Problem determination
 Collect the following diagnostic items:
Console output from the system on which the job was run, and a listing of the
SYSLOG data set for the period of time that spans the failure. 

A listing of the SYS1.LOGREC data set, obtained by executing IFCEREP1.