Monitoring DDF problems by using NetView
The NetView program lets you have a single focal point from which to view problems in the network. DDF sends an alert to NetView when a remote location is either involved in the cause of the failure or affected by the failure.
About this task
To see the recommended action for solving a particular problem, enter the selection number, and then press Enter. This displays the Recommended Action for Selected Event panel, shown in the following figure.
N E T V I E W SESSION DOMAIN: CNM01 OPER2 11/03/89 10:30:06
NPDA-45A * RECOMMENDED ACTION FOR SELECTED EVENT * PAGE 1 OF 1
CNM01 AR 1 AS 2
+--------+ +--------+
DOMAIN RQST --- SRVR
+--------+ +--------+
USER CAUSED - NONE
INSTALL CAUSED - NONE
FAILURE CAUSED - SNA COMMUNICATIONS ERROR:
RCPRI=0008 RCSEC=0001 1
FAILURE OCCURRED ON RELATIONAL DATA BASE USIBMSTODB21
ACTIONS - I008 - PERFORM PROBLEM DETERMINATION PROCEDURE FOR REASON
CODE 3 00D31029 2
I168 - FOR RELATIONAL DATA BASE USIBMSTODB22
REPORT THE FOLLOWING LOGICAL UNIT OF WORK IDENTIFIER
DB2NET.LUND0.A1283FFB0476.0001
ENTER DM (DETAIL MENU) OR D (EVENT DETAIL)
- Key
- Description
- 1
- The system that is reporting the error. The system that is reporting the error is always on the left side of the panel. That system name appears first in the messages. Depending on who is reporting the error, either the LUNAME or the location name is used.
- 2
- The system that is affected by the error. The system that is affected
by the error is always displayed to the right of the system that is
reporting the error. The affected system name appears second in the
messages. Depending on what type of system is reporting the error,
either the LUNAME or the location name is used.
If no other system is affected by the error, this system does not appear on the panel.
- 3
- Db2 reason code.