Use the CURRENT SPUFI DEFAULTS - PANEL 2 panel to specify
default plan name information.
This panel opens if you specify YES in the CHANGE PLAN
NAMES field of the CURRENT SPUFI DEFAULTS panel.
Figure 1 shows
the initial default values. Figure 1. CURRENT SPUFI DEFAULTS - PANEL 2
DSNESP07 CURRENT SPUFI DEFAULTS - PANEL 2 SSID: DSN
===>
Enter the following to control your SPUFI session:
1 CS ISOLATION PLAN ===> DSNESPCS (Name of plan for CS isolation level)
2 RR ISOLATION PLAN ===> DSNESPRR (Name of plan for RR isolation level)
3 UR ISOLATION PLAN ===> DSNESPUR (Name of plan for UR isolation level)
Indicate warning message status:
4 BLANK CCSID WARNING ===> YES (Show warning if terminal CCSID is blank)
PRESS: ENTER to process END to exit HELP for more information
The following descriptions explain the information on
the CURRENT SPUFI DEFAULTS - PANEL 2 panel.
1 CS ISOLATION PLAN
Specify the name of the plan that SPUFI uses when you specify
an isolation level of cursor stability (CS). By default, this name
is DSNESPCS.
2 RR ISOLATION PLAN
Specify the name of the plan that SPUFI uses when you specify
an isolation level of repeatable read (RR). By default, this name
is DSNESPRR.
3 UR ISOLATION PLAN
Specify the name of the plan that SPUFI uses when you specify
an isolation level of uncommitted read (UR). By default, this name
is DSNESPUR.
4 BLANK CCSID ALERT
Indicate whether to receive message DSNE345I when the terminal
CCSID setting is blank. A blank terminal CCSID setting occurs when
the terminal code page and character set cannot be queried or if they
are not supported by ISPF.
Recommendation: To avoid possible
data contamination use the default setting of YES, unless you are
specifically directed by your Db2 system
administrator to use NO.