Using the HBACKDS line operator
Use the HBACKDS line operator on the ISMF DATA SET LIST
panel
to create DFSMShsm logical
backups.
You can enter HBACKDS for any data set in the ISMF data set list. The HBACKDS
ENTRY PANEL
is displayed. Use this panel to specify parameters for the DFSMShsm logical
backup.
Panel Utilities Help
------------------------------------------------------------------------------
HBACKDS ENTRY PANEL
Command ===>
Optionally Specify one or more for
Data Set: CICSMVS.BASE1.SPH1
Target . . . . . . . . . . . . . (D=DASD, T=TAPE or blank)
Concurrent copy . . . . . . . . (R=Required, P=Preferred,
S=Standard or blank)
For R or P, enter CC option (P=PHYSICAL, L=LOGICAL or blank)
Wait for Completion . . . . . . N (Y or N)
Data Set Password . . . . . . . (if password protected)
Use ENTER to Perform Hbackds;
Use HELP Command for Help; Use END Command to Exit. After you enter the backup parameters and press Enter, DFSMShsm creates the logical backup. The CICS® VR dialog interface retrieves information about this backup from DFSMShsm when constructing the recovery job.
Exception: The CICS VR address space does not have to be active for CICS VR to access information from DFSMShsm.