Removing an HS Expander module

Edit online

About this task

CAUTION:
Removing this hot-swappable PCBA disrupts the enclosure’s airflow. Do not remove the PCBA until you have received the replacement. It is important that all CRU module slots are filled when the enclosure is in operation.

Procedure

  1. Remove the top lid “A” to access the HS Expander module. See Figure 1
  2. On the faulty HS Expander, grasp each of the two plastic swing-arms between thumb and index finger as shown in the figure below.
    Figure 1. Removing an HS Expander (1 of 2)
    Remove HS expander fig 1 of 2
  3. Revolve each swing-arm upward to release the PCBA carrier from its slot as shown in the figure below.
    Figure 2. Removing an HS Expander (2 of 2)
    Remove HS expander fig 2 of 2
  4. While grasping the swing-arm handle, pull upwards to lift the HS Expander and remove it from its slot.