About this task
Refer to Figure 1 and
Figure 2
when performing this procedure, but ignore the directional arrows - since you will insert the module
into the slot - rather than remove it.
Important: Handle the PSU carefully, and avoid damaging the connector pins. Do not
install the PSU if any pins appear to be bent.
Procedure
-
Check for damage, especially to all module connectors.
-
With the PSU handle in the open position, slide the module into the enclosure, taking care to
support the base and weight of the module with both hands.
-
Lever the module home by manually closing the PSU handle. You should hear a click as the latch
handle engages and secures the PSU to its connector on the back of the power mid-plane.
-
Connect the power cable to the power source and the PSU.
Power cables are typically routed to the PSU from the cable management arm (CMA). Verify that the
180º power cable bends lie flat in the CMA baskets. Route the cables as shown in 3 of Routing cables using the CMA,
ensuring they lay flat on the CMA shelf and through the PSU cable clips assembly. See also Enclosure rear panel.
-
Verify that the bi-tonal PSU Status LED is on/green. Verify that cooling fans are spinning with
no fail states. Verify that the front panel LED states show no amber module faults.
-
Repeat this procedure if replacing two PSUs. Keep in mind the Enclosure rear panel
illustrations TIP