Installing an HS Expander module

Edit online

About this task

Refer to Figure 1 and Figure 2 when performing this procedure, but ignore the directional arrow - since you will insert the module into the slot - rather than remove it.
Important: Handle the HS Expander module carefully to avoid damage to the connector and swing arms.

Procedure

  1. Check for damage, especially to all module connectors.
  2. Align the controller HS Expander module for use in the module slot that is accessible from the top panel along the right wall of the enclosure.
  3. Insert the controller module into the slot, and gently press down on the module until it seats firmly in its connector.
  4. Verify that the HS Expander Status LED is off. Verify that the front panel LED states show no amber module faults.
  5. If replacing multiple HS Expanders, repeat Step 1 through Step 4
  6. Reattach top lid “A” when you complete the procedure.