Release the drive carrier handle by pressing the latch in the carrier handle towards the handle
hinge to release the carrier handle as shown in the figure below.
Figure 1. Drive carrier module in open position
Insert the drive carrier module into the enclosure. Make sure that the drive carrier is
positioned such that the front face of the disk is facing up, and the handle opens from the left as
you face the enclosure top panel. The module should be revolved such that its horizontal axis is
parallel to the chassis longitudinal axis, as shown in the figure below.
Figure 2. Installing a drive carrier module (1 of 2)
Slide the drive carrier fully into the disk slot within the enclosure.
Continue to push firmly until the handle fully engages. The camming foot on the carrier will
engage into a slot in the enclosure. You should hear a click as the latch handle engages and holds
the handle closed.
Figure 3. Installing a drive carrier module (2 of 2)
Verify that the amber Fault LED on the disk module handle is off. Verify that the front panel
LED states show no amber module faults. The enclosure front panel Drive Activity blue LED will blink
to show disk activity.
