Operation

Before you begin
Before you power on the enclosure, make sure that all the modules are firmly seated in their correct bays.
Power on
Instructions for applying power to the enclosure.
Ops panel LEDs
Ops panel LEDs indicate fault and status conditions.
Unit identification number
After a unit identification number is set, it is stored in the midplane VPD by the Enclosure Management software and appears when the enclosure is next powered on.
Power down
Lock the drawers
A drawer can be locked shut by using a screwdriver with a Torx T20 bit to rotate both anti-tamper locks until the red arrows point away from the center of the enclosure.

Parent topic: Slicestor® 2584 Appliance Manual