Installing and configuring IBM Sterling Control Center Monitor on z/Linux

You can install the IBM® Sterling Control Center Monitor engine and console in a z/Linux environment.

  • Define localhost in etc/hosts.
  • Set ulimit to unlimited for the user that installs IBM Sterling Control Center Monitor.
Use this procedure to install the engine and console in a z/Linux environment.
Note: If you are upgrading from a prior version of IBM Sterling Control Center Monitor, see Release Notes.
  1. Transfer the CCInstall64.bin file to the computer where IBM Sterling Control Center Monitor will be installed.
  2. Start the installer using the following syntax: 
    sh CCInstall64.bin
  3. Specify appropriate values for all the prompts including the installation location.
  4. After the installation is done, run configCC.sh to configure the engine.
    Attention: During the Event Processor Name installation step, you can use only alphanumeric characters to name the event processor. The event processor name must be unique in the database.