Component step - routing properties

On the Routing tab on the Properties pane, specify the routing options for both incoming and outgoing routes.

To specify incoming routing:

If the current step will act as a collector step (an AND-join) for a previous AND-split step, select Collector Step under Incoming Routing Information; otherwise, clear the Collector Step check box.

To specify outgoing routing:

• If work should proceed on only one valid route from this step, or if there is only one route, select First true condition. In the list of routes from this step, specify the order that the routes should be evaluated at runtime. Use the up and down arrows as necessary.

  To see any conditions specified for a route, select the route.

• If there can be multiple true conditions and work can proceed on multiple routes from this step, select All true conditions.

  This creates an AND-split; you must specify a corresponding AND-join for a subsequent step. See Specify incoming routing for information about creating a collector step (AND-join).