About this task
Use the following procedure to set up SNMP Support.
Note: Before
performing this procedure, migrate the CDMIB and IBM® Connect:Direct® Trap
Configuration files to HP OpenView. Refer to Customizing SNMP in Installing IBM Connect:Direct in
the IBM
Connect:Direct for z/OS® Configuration
Guide for more information.
Procedure
- Specify SNMP=YES in the initialization parameters file.
- If you want to exclude or disable any trap
event or define additional trap triggers described in Identifying Trap Variables,
create a data set containing all the trap events that you want to
disable. Following is an example.
Note: All traps are enabled
by default.
sendStatusTraps = N
statsDisabled = N
statsStress = N
statsStressResolved = N
userMessageAlarm = ( SVTM100I , SVTM101I )
|
A sample SNMP.DSN file is in the $CD.SDGASAMP data set,
member DGAXSNMP.
If you do not want to exclude
any trap events, go to step 4.
- Set the SNMP.DSN initialization parameter to the data set
name created in step 2.
- Set the SNMP.MANAGER.ADDR initialization
parameter. This parameter is the TCP/IP address or hostname of the
host where the SNMP Network Manager is initialized. By default, this
address is the same as the TCP/IP address that IBM Connect:Direct is
using or the local hostname. In a IBM Connect:Direct/Plex
environment, the default is the TCP/IP address of the IBM Connect:Direct Manager.
This parameter is required if the network manager resides on a different
host or is required to use a different TCP/IP address. Following is
an example.
SNMP.MANAGER.ADDR=123.4.5.6
|
- Set the SNMP.MANAGER.PORTNUM initialization parameter.
This port is the TCP/IP port that is defined for UDP traffic to the
network manager. The default is 162. This parameter is required if
the defined UDP port number is something other than 162. Following
is an example.