Issuing CHANGE PROCESS through the Batch Interface

To use the CHANGE PROCESS command from the Batch Interface:

  1. Place commands in the DGADBATC job stream as described in Sample Job Stream to Run the Batch Interface.
  2. Submit the job while IBM® Connect:Direct® is running.

    A report similar to the following is displayed:

    ===================================================================
                          CHANGE PROCESS
    ===================================================================
    PROCNAME PROCNUM_ SUBMITTER_NODE__ SNODE.NAME______ MESSAGE________
    USERID___________
    -------------------------------------------------------------------
    DMNOTEST 271      node.name        node.name        DEST CHANGED
    USER01
    -------------------------------------------------------------------
  3. Check this report to verify your results.