-
Access IBM Navigator for i.
-
Click Content Manager OnDemand,
and verify the current instance.
-
Click Tape Volumes and then click Add.
-
First, specify the name of the tape volume that you want to make available to Content Manager OnDemand.
The volume name must match the name you used when you initialized the tape volume on your IBM i server. For the system configuration example that is
described previously, the name of the volume is OND001.
-
Next, specify the total capacity of the tape volume in
megabytes.
For the example, specify a capacity of 2300
MB.
-
For media type, use the pull down to select the correct
type.
For the example, select 8MM, and leave media device
library blank.
-
The migration policy, which will be created
later, will request a tape backup. So, for this example, make the
volume type Backup. If, instead, the plan was to use this tape volume
for the primary archive media for some of the Content Manager OnDemand data, you would leave the
volume type set to Primary. For this example,
however, set the volume type to Backup.
Make sure Tape is full is not checked.
-
Click OK to add the tape volume
to Content Manager OnDemand.