Running the probe

You can run the probe from the command line.

To start the probe , use the following command:

$OMNIHOME/tsm/nco_t_tl1

Note: This is the standard procedure for running any probe . However, if you encounter an error stating that the file cannot be found in $OMNIHOME/probes/arch, start the probe , using the following command:

$OMNIHOME/tsm/nco_t_tl1 -propsfile $OMNIHOME/tsm/arch/tl1.props -rulesfile $OMNIHOME/tsm/arch/tl1.rules