ProbeWatch messages

During normal operations, the probe generates ProbeWatch messages and sends them to the ObjectServer. These messages tell the ObjectServer how the probe is running.

The following table describes the raw ProbeWatch error messages that the probe generates. For information about generic ProbeWatch messages, see the IBM Tivoli Netcool/OMNIbus Probe and Gateway Guide.

Table 1. ProbeWatch messages
ProbeWatch message	Description	Triggers/causes
`Start monitoring configuration file.`	The probe started to monitor configuration file changes.	The probe started.
`Stop monitoring configuration file.`	The probe stopped monitoring.	The probe stopped.
`Config file has changed, need refresh :configFile`	The probe detected configuration file changes.	The probe detected that one of the configuration files has changed.
`Start log configuration refresh`	The probe started a real time configuration refresh.	The probe detected that a log file changed and is executing a real time refresh..
`Remove event log monitoring : logfile`	You should remove the displayed log from the configuration file.	The probe has detected an error in the log file.
`Finished log configuration refresh`	The probe completed processing the changes in the configuration file.	The probe detected that one of the configuration files changed and it executed a refresh.
`Start listening for event from : logfile`	The probe starts to monitor for new events in the specified log.	The probe started or a new log had been detected.
`Fail to listen for event from: logfile`	The probe failed to monitor events in the specified log.	This could be a system error. Try running a separate probe to troubleshoot this log.
`Start to resync : logfile`	The probe started a resynchronization operation.	The probe started or a new log had been detected.
`Finished resync : logfile`	The probe completed a resynchronization operation.	The probe started or a new log had been detected.
`Fail to resync : logfile`	The probe resynchronization operation failed.	The probe was unable to resync. Check if there is any event in EventViewer to resync.