Path status log files

The following table describes the elements that the Probe for Alcatel-Lucent 5620 Logfile generates for events read from path status log files.

Table 1. Elements for path status log files
Element name	Element description
`$bandwidth`	This element shows the bandwidth used.
`$call_id`	This element contains the call identifier.
`$call_type`	This element indicates the call type.
`$change_mask`	This element contains the changed mask parameter. This value is only valid if null value is shown for the `$old_dest` and `$new_dest` elements.
`$dateandtime`	This contains specifies the date and time when the alarm occurred.
`$error`	This element contains the line in the alarm that caused the error.
`$new_dest`	This element contains value for the new destination. This element is only valid if the source and destination values are different.
`$new_source`	This element contains the new source parameter value.
`$old_dest`	This element contains value for the old destination. This element is only valid if the source and destination values are different.
`$old_source`	This element contains the old source parameter value. This value is only valid if the `$new_dest` element shows a non-null value.
`$partition_id`	This element shows the partition identifier.
`$path_end_idA`	This element indicates the identifier of path-end A.
`$path_end_idB`	This element contains the identifier of path-end B.
`$path_name`	This element shows the path name.
`$path_number`	This element contains the path number.
`$path_status`	This element indicates the path status.
`$path_type`	This element shows the path type (voice, data, DSO, and so on).
`$rapid`	This element indicates the RAPID protection (`0` - disabled, `1` - enabled).
`$reconfig`	This element contains the reconfiguration message.
`$source`	This element indicates the source of the data.