Defining project areas

Edit online
Draft comment:
This topic only applies to BAW, and is located in the BAW repository. Last updated on 2025-03-13 12:15
Draft comment:
This topic was viewed 74 times since its publication
You can define new, non-default project areas, assign solutions and users to a project area, and remove project areas.

Before you begin

Be sure to have your completed configuration checklist available.

About this task

You can define project areas for the development environment by using the IBM® Business Automation Workflow administration client. After you define a project area, you must register it before you can use it.

Restriction: Each project area requires a unique connection point, and only one connection point can be associated with a target object store.

Procedure

To define a new project area:

  1. Start the Case administration client.
    Enter the following URL in a browser:
    http://server:port/navigator/?desktop=bawadmin
    where server is the IBM Content Navigator IP address or fully qualified server name, and
    port is the IBM Content Navigator port number.
  2. In the navigation tree in the left panel, select a design object store and click Project Areas.
  3. On the Project Areas panel in the right panel, click Define and complete the steps.
  4. Register the project area.
    1. On the Project Areas panel in the right panel, select the project area to register.
    2. Click Actions > Register and complete the steps.
      Note: The configure case integration is internally handled by the register project area task.
  5. On the Project Areas panel in the right panel, click Actions > Register and complete the steps.
    Note: The JMS information page in the steps is specific to Cloud Pak for Business Automation configurations.

What to do next

Set security for the project area users. Account-wide setting should be used.