Terminate a volume

You can use the TERMINATE command to end a TDMF volume pairing dynamically.

Under Requested Action, enter T to terminate a volume or TG to terminate a group and press the Enter key. If the Terminate Group on Error option was selected, a selection of T defaults to TG. The following figure shows the confirmation panel.

Figure 1. Confirm termination panel

                     Volume Confirmation Screen            Row 1 to 1 of 1
ComDataSet:  . . . . : GTD.V.SYSCOM
Confirmation required to Terminate a Volume.
Volume Serial No.  . : SPMS86
Confirm? (YES/NO): . . ___
Command ===>
 F1=Help    F2=Split   F3=Exit    F9=Swap   F12=Cancel

Note: After TDMF enters Approval Mode, the TERMINATE command ends the migration with the original target volume as the source volume. The TERMINATE command has the same effect as APPROVE[Yes]. After the session is terminated, a new migration is required if you need to go back to the original source volume.