Step 2 - Performing a frame roll installation

This topic describes how to do a frame roll installation. The frame roll installation applies customer data and system settings from a USB flash memory drive to a TKE workstation. This task is the second step in the process of migrating customer data from a source TKE workstation to a target TKE workstation.

1. Insert the TKE installation DVD into the DVD drive on the target TKE workstation.
2. Restart the TKE workstation:
   1. Select Service Management.
   2. Select Shutdown or Restart.
   3. Select Restart Console.
   4. Click OK. A Confirm Shutdown or Restart window opens.
   5. Click Yes.
   The workstation restarts. It can take over seven minutes for it to restart.
3. On the Trusted Key Entry: Upgrade / Install Recovery / Frame roll window, enter 3 to select frame roll and click Enter.
4. Enter 1 and click Enter to start the frame roll installation. The DVD drive opens and you see a message window with OPERATION SUCCESSFUL at the top.
5. Follow the instructions in the message window:
   1. Insert the USB flash memory drive that contains the save upgrade data, if it has not already been inserted.
   2. Remove the TKE installation DVD from the DVD drive. You can manually close the drawer or let it close automatically in the next step.
   3. Click Enter to restart the TKE workstation.
   The TKE workstation restarts several times. It can take over ten minutes to complete the restarts. When the frame roll installation is complete, the TKE: Trusted Key Entry Console Workplace window opens.