Viewing the output

The following figure shows an example of the panel when viewing a report.

Figure 1. Viewing a sample report

HCD tries to display the entire configuration on one panel. If a report is too large for one panel, HCD divides the report into segments and shows each segment on an extra panel. If a CU report, for example, shows more than 8 control units, HCD shows the control units of the same type in one segment on an extra panel. You can move from segment to segment by using the Next and Previous function keys.

If a segment of control units is too large for the panel, you can scroll upwards, downwards, to the left and to the right.

The following list describes specific function keys while viewing a graphical report.

F4=Jump: You can use this function only when you have displayed the graphical report using the task Create or view graphical configuration report on the Primary Task Selection panel. It displays the action list of the HCD dialog that contains the object you selected with the cursor. Any change made to the configuration on the action list will not be reflected in the graphical report when you return to it. Use the REFRESH command to reflect the changes made to the objects currently shown on the display (see Refresh Command).
F5=Zoom in: Makes the graphical display bigger, so you can see the details of an object. The position of the cursor identifies the lower left corner of the part you want to enlarge. If the cursor in not positioned, HCD takes the center of the currently displayed report.
F6=Zoom out: Makes the graphical display smaller, so you can see more of a report on one panel.
F7=Up: Scrolls upwards.
F8=Down: Scrolls downwards.
F10=Previous: Moves to the previous segment of a report, if any.
F11=Next: Moves to the next segment of a report, if any.
F19=Left: Scrolls to the left.
F20=Right: Scrolls to the right.