AdStops window (CMS only)

The AdStops window can only be opened when PER operation is active. It is opened by issuing the ADSTOPS command without providing any arguments. To close the window, issue the ADSTOPS command again without any arguments or issue the CLOSE command against that window. When the AdStops window is opened, it is positioned at the bottom right corner of the screen, and overlays any information there.

Alternatively, you can use the REGSTOPS command.

The AdStops window lets you set and reset register alteration stops (RegStops) or clear storage alteration stops (AdStops).

Figure 1. AdStops window

 ┌01─AdStops──────────────────────────────────────────────────┐
 │ PER Register Stop (RegStop) on:                            │
 │  R0 N  R4 N  R8 N R12 N                                    │
 │  R1 N  R5 N  R9 Y R13 N                                    │
 │  R2 N  R6 N R10 N R14 N                                    │
 │  R3 Y  R7 N R11 N R15 N                                    │
 │                                                            │
 │ PER Address Stop (AdStop) ranges:                          │
 │ 1. 000202E0 (SUBJOB) @DL00101                              │
 │    00020306 (SUBJOB) @DE00103                              │
 │ 2. Free                                                    │
 │    Free                                                    │
 │ 3. Free                                                    │
 │    Free                                                    │
 │ 4. Free                                                    │
 │    Free                                                    │
 └────────────────────────────────────────────────────────────┘

To clear a storage alteration stop, just place the cursor on the field describing the stop you want to clear, and either press the ERASE-EOF key or overtype the field with blanks. You must clear both the start and the end address.

Change the register stop settings by overtyping the values shown.