ASMA998U

The assembler could not resume reading a LIBRARY member because
it could not FIND the member again
Explanation
The assembly stops, because the assembler cannot find a COPY member
that it has already read. This is typically caused by an
error in the assembler itself or by an Operating System I/O error.
Under certain conditions, however, the assembly can be rerun successfully.

System action
A special abnormal termination dump (High Level Assembler interrupt
and diagnostic dump) follows the message. The dump normally indicates
which statement caused termination. It also might include contents
of the assembler registers and work areas and other status information
for use by IBM or your assembler maintenance programmers in determining
the cause of the termination.

Programmer response
Reassemble the program; it might assemble correctly. If it does
not reassemble without error, save the abnormal termination dump,
the assembly listing (if one was produced), and the input sources,
and contact IBM for support.

Severity
20