ERROR encountered during STL translation

STL translation is done immediately after capturing a WTM testcase or changing STL msgutbl source files relating to a testcase. If the STL translation encounters an error, do the following actions:

1. Browse the print output of the STL translate step.
2. Type F '*** ERROR' on the command line and then press ENTER. Take note of the places in the STL or UTBL where translation failed along with the reasons for the failure. The message helps you find the reason for the error.
3. Search for the next error by pressing PF5, and note all subsequent errors. Continue pressing PF5 until no more "*** ERROR" lines are found.
4. Edit the STL or UTBL source where errors were encountered and make the appropriate corrections. If you don't understand a given error, consult WSim Script Guide and Reference. For a more detailed explanation of the error message, refer to WSim Messages and Codes.
   Note: If you are running WTM in Interact mode, you can end the Browse session and press PF4 to make STL changes.