Backup mode commands

Backup mode provides the commands to set the backup mode for the DataPower® Gateway when not prompted during initialization.

To enter the mode, use the global secure-mode command. You can use the commands only when the initialization of the DataPower Gateway does not prompt you to set operational modes.

While in this mode, use the commands in the following table to set the Secure Backup operational mode.

To view the current configuration, use the show command.
To restore default values, use the reset command.
To exit this configuration mode without saving changes to the running configuration, use the cancel command.
To exit this configuration mode and save changes to the running configuration, use the exit command.

Table 1. Backup mode commands
Command	Purpose
admin-state	This command sets the administrative state for the configuration.
mode	This commands sets whether to support the Secure Backup operational mode.