link-aggregation

This command enters Link Aggregation mode to manage the configuration of aggregate interfaces. Before you configure an interface, obtain the essential network data from your network team.

Syntax

Enters the mode to create or modify an aggregate interface configuration: link-aggregation name
Deletes an aggregate interface configuration: no link-aggregation name

Availability

All platforms, except Docker and Linux®.

Parameters

name: Specifies the name of the configuration. The name cannot be a single period or two consecutive periods. The name can contain a maximum of 128 alphanumeric characters and the following special characters: . - _

Guidelines

The link-aggregation command enters Link Aggregation mode to manage the configuration of aggregate interfaces. An aggregate interface can contain only Ethernet interfaces.

Before you can add an Ethernet interface, you must use the link-aggregation-mode command in Interface mode to set the Ethernet interface as part of an aggregate interface. While an Ethernet interface is part of the aggregate interface, you cannot change its administrative state.

Use the no link-aggregation command to delete the configuration for an aggregate interface.