Resolving a VGA monitor problem

Learn how to identify the service action that is needed to resolve a video graphics array (VGA) monitor problem.

Procedure

  1. Is the system powered on and is the VGA monitor connected to the VGA display port, but no video is displayed?
    If Then
    Yes: Continue with the next step.
    No: Power on the system. This ends the procedure.
  2. Complete the following steps, one at a time until the problem is resolved:
    1. Ensure that the network image that is specified is a valid boot image.
    2. Ensure that the VGA cable is properly seated to the server port and to the monitor port.
    3. Verify that your monitor and your VGA cable are working properly by testing them on a system that is known to be working properly. If the monitor or the VGA cable does not work properly, replace it.
    4. Verify that the system is powered on by activating a serial over LAN (SOL) session through the baseboard management controller (BMC). If the system is not active, go to Resolving a system firmware boot failure.
    5. Replace the system backplane. Go to 7063-CR2 locations to identify the physical location and the removal and replacement procedure. This ends the procedure.