Removing the rear USB cable from the 5105-22E, 9008-22L, 9009-22A, 9009-22G, 9223-22H, or 9223-22S system

To remove the rear USB cable, complete the steps in this procedure.

Procedure

  1. Ensure that you have the electrostatic discharge (ESD) wrist strap on and that the ESD clip is plugged into a ground jack or connected to an unpainted metal surface. If not, do so now.
  2. Label and remove any cables from the USB port.
  3. While pressing the latch release on the connector, unplug the rear USB cable (A) from the system backplane as shown in Figure 1,
    The connector on the system backplane that has the USB port symbol with an arrow that points to the rear of the system.
    Figure 1. Removing the rear USB cable
    Removing the rear USB cable
  4. At the rear of the system, open the adapter latch (B) and lift the USB cable housing (C) as shown in Figure 1.
  5. Lift the rear USB cable out of the system.