Placing an 8001-22C or 8005-22N system into the operating position

Learn how to place an IBM® Power® System S822LC for Big Data (8001-22C) or the IBM CS822 (8005-22N) system into the operating position.

1. Lift the system from the table.
2. Tilt the system into position over the rails.
3. Carefully lower the system onto the rails.
4. Release the rail safety latches (A) by lifting them upward, as shown in Figure 1, then push the system fully into the rack.
   Figure 1. Placing the system into the operating position

   
5. Fasten the two front screws (C) to secure the system to the rack.
6. Using your labels, reconnect the cables at the rear of the system unit.
7. Using your labels, replace the drives in the proper locations.
8. Replace the power supplies.