You can use the Hardware Management Console (HMC) to perform many service
actions, including the removal of a field replaceable unit (FRU) or
part.
To remove a part in a system or expansion unit that is
managed by HMC Version
7, or later, complete the following steps:
- In the navigation area, expand .
- Select the managed system from which you are removing a
part.
- In the Tasks area, expand
- In the Add/Install/Remove Hardware - Remove FRU, Select
FRU Type window, select the system or enclosure from which you are
removing the part.
- Select the type of part that you are removing, and click Next.
- Select the location of the part that you are removing,
and click Add.
- After the part is listed in the Pending Actions section,
click Launch Procedure and follow the instructions
to remove the part.
Note: The HMC might open the information
center instructions for removing the part. If so, follow those instructions
to remove the part.
Subscribe to this information