If you removed the Redundant Array of Independent Disks
(RAID) enablement card as a part of another procedure, you might need
to replace the card. Use the procedure in this section to perform
this task.
You must have already completed the procedure Removing the RAID enablement card.
To
replace a RAID enablement card, complete the following steps:
- Locate the slot for the RAID enablement card
Figure 1. Slot location for the RAID enablement
card installation
- Align the RAID enablement card with the slot in the system.
- Slide the RAID enablement card fully into the system until
the tab (A) locks into place.
Figure 2. RAID enablement card replacement
in a rack-mounted system unit
- Replace the service access cover. See Installing the service access cover on a rack-mounted
8233-E8B or 8236-E8C
- Place the system in the operating position. See Placing a rack-mounted 8233-E8B or 8236-E8C in the operating position.
- Start the system. For instructions, see Starting a system or logical partition.
- If you replaced the RAID enablement card as part of another
procedure, return to that procedure now. If you replaced
the RAID enablement card because it was not operational, verify that
the new resource is functional. For instructions, see Verifying
the installed part.
Subscribe to this information
